Optical Pulse Machines (OPM)                 

OPM offers a variety of accessories to ensure an easy integration of our module in your laser system.

 Extension Cord 

OPM-EXT40-2

The 50cm extension cord has 40 wires with male to female connectors.

The extension cord interconnects between all OPM modules to the test jig so you may integrate the OPM modules into your laser system while the powering and trigger signal are still coming from the test jig.  

For OEM integration in your system you may connect the female connector to the OPM module, cut the male connector and connect the wires to your system.

 __

 RF Cable SMA-MCX (male) 

OPM-SMA-MCX-M

 The MCX connector side of this cable fits all of OPM's modules that have a current monitor. 

 The SMA connector shall be connected to your oscilloscope for laser current monitoring.

This cable can also be used for the trigger output signal of the OPM-LD-ps module.

Cable length is 30cm.

 RF Cable SMA-MCX (female)

 OPM-SMA-MCX-MF

 The MCX connector side of this cable fits the AWG electrical outputs in the OPM-LD-ps module. 

Connecting the AWG output to OPM-AMP-700 (also using the SMA-BNC adaptor) will enable you to drive an MZ modulator.

Cable length is 30cm.__

SMA-BNC Adaptor

OPM-SMA-BNC-ADP

 We offer the SMA-BNC Adaptor as part of a system that drives arbitrary wave-forms to a MZ modulator.

 
_

 _ 

Filter 1GHz

OPM-FILTER-SMA-1G

This is a 1GHz low-pass-filter that is used to remove unwanted residual noise from the AWG's electrical outputs. 

We offer the filter as part of a system that drives arbitrary wave-forms to a MZ modulator.

 _

SMA Terminator 50 ohm

OPM-Term-SMA-50

This is a 50 ohm RF terminator that is used to terminate the un-connected output of the AWG's electrical output. 

We offer the filter as part of a system that drives arbitrary wave-forms to a MZ modulator.